M10 Solid Axle Nut Set
Protect your solid axle hub with Pitlock security. These M10 nuts are compatible with any 10MM x 1MM threaded axle, such as Rohloff TS Speedhubs and Miche Primato rear hubs. See our compatibility chart for additional details.
This set comes complete with the necessary components for installation: two solid axle nuts, stepped washers, teflon rings, lock housing, and up to two keys.
See below for additional product and sizing specifications.
This set contains two 10MM x 1MM solid axle nuts, and up to two keys.
Set #M10 is intended for any 10MM x 1MM threaded axle (an outside axle diameter of 10mm, and a thread pitch of one millimeter.) This includes Rohloff TS Speedhubs, NuVinci / Enviolo (n330, n360 and n380), Miche Primato Pista, SRAM Automatix, and SRAM DD3 hubs.
If your front and rear hubs are differently sized, or if you only need one nut, please build a custom solid axle set instead.
Pitlock’s solid axle nuts use the same technology as their quick release counterparts, but they are considerably larger. Because of the size difference, if you decide to use these nuts in conjunction with a Pitlock seatpost or ahead bolt, you will need to use two different keys.
Additional notes: These bolts are a full 1-3/16″ (30.16MM) in diameter at the base. Please be sure to measure the area around your dropouts to confirm that you have room for these. The protruding thread is supposed to stick out of the dropout for approximately 14 mm. In case the protruding thread is too short, it is necessary to use an axle stub with a long threaded axle (which is available from Rohloff, article number: 8235L Axle Plate.)
Without keys, With One (1) Key, With Two (2) Keys